Test 10 Videos

 

This unit covers the Haas Minimill machine and control panel general layout and modes of operation and display. Preliminary checks and the start up sequence is discussed. Loading tool holders and starting the machine spindle is described. We describe the orientation of the machine axes, and the methods for manually causing machine motion. After finishing these units the student will use the machine to finish mill the side of a workpiece.

 

10.01 Prelim Check
This unit describes the checks which should be made on the Haas Minimill before turning power on.
10.02 Startup
This unit describes the specific sequence required to start the machine, and the process to confirm that the machine has been started correctly.
10.03 Control Panel
This unit will describe the general arrangement of the Control Panel on the Haas Minimill.
10.04 Operation & Display Modes
This unit we will be talking about the various operating and display modes for the Haas Minimill controller.
10.05 Tool Load
In this unit we will be showing the method for loading the tool and toolholder into the machine spindle.
10.06 Spindle Start
In this unit we are going to describe how to start the machine spindle.
10.07 Axes
At the end of this unit the student will be able to describe the 3 primary axis orientations on the vertical machining center, select one axis, and cause the machine spindle to move in the selected axis.
10.08 Handle
In this unit the operator will learn to move the tool, efficiently, to any specified position within the machine travel.
10.09 Jog
At the end of this unit the operator will be able to cause the spindle to move at a specified jog feed rate in any single axis direction.
10.10 Application
In this unit, we will put together all of the material from the previous videos plus the students manual machining experience, to finish mill the side of a piece of material.